Hydraulic Thread Rolling Machine Manufacturer

24 Ton Hydraulic Spline Rolling Machine:

Hydraulic Thread Rolling Machine Manufacturer
Hydraulic Thread Rolling Machine Manufacturer

This Spline Rolling Machine with Special Tooling and with HMI is designed for rolling starter motor helical splines with partially skipped tooth form i.e., 12 teeth and 6 teeth for Lucas TVS. Components up to 1.5 module can be rolled on this 24 ton Hydraulic Spline Rolling Machine .

Specifications of our 24 ton Hydraulic spline Rolling Machine
Maximum Thrust for rolling 24 ton
Maximum Roll diameter 200 mm
Bore size 54 mm std./69.85 mm
Max. Roll width 125 mm
Max. Diameter of the job 60 mm
Max. Pitch 4 mm
Max. spline 1.5 mod. (higher with helix)
Min. Job diameter 6 mm
Max. spline length 150 mm std. (higher available)
Max. Job length 400 mm between centre
Max. Swing of the Job (Flange Dia) 125 mm
Roll Shaft RPM Infinitely variable 0-50 RPM std.
Gearbox Hardened and ground helical gears(no worm & worm gears)
Lubrication Centralized lubrication with PLC controls
Electrical Control PLC with 24 Volts DC
Slide movement Both roll shafts move towards center on Imported Linear Guides, hence the job is centrally placed always.
Depth/Size control With positive arrangement
Rolling cycle Spline Rolling –Force Feeding System of rolling, Plunge Rolling Cycle.
Connected load (approx.) 12 HP approx
Floor space 1.75 x 1.75 meters.
Weight of the machine 3 tons approx.
Construction Machine grade cast iron body mounted on stress relieved welded body, single piece construction, epoxy coated hydraulic and coolant tank inside the machine.
Electricity The total consumption of electricity will be less on our machine, because of higher efficient gearbox and Variable Speed Drive, for which lower HP motors are used. This will pay back your investment in a short period.
The Hand of JESUS has done this